Guide safely and draw professionally.

Drawing wires involves expending a great deal of energy to create a super-fine, uniform product that demonstrates the same physical properties at all points. This requires a reproducible process. This in turn is highly dependent on the equipment used, such as drawing cones, drawing rings and drawing capstans, as the end product will only remain perfect if these components can also ensure the same levels of friction and resistance over a long period of operating time.

HOFMANN CERAMIC also offers all additional ceramic components needed for wire or thread guidance. They are wear-resistant, have good anti-frictional properties and are acid and heat resistant.

The abrasive effect of wires can have far-reaching consequences. This demands the highest quality possible, for every time a replace- ment is required, it also means production is halted. According to specific requirements, we can make drawing tools for you from various materials. In addition to fully ceramic tools, we can also offer ceramic and metallic coated components. All of this is available at very good terms and in small runs.